What is the door Jamb?
The JAMB door is a vertical part of the door frame that acts as support for the rest of the frame, as well as for the door itself. Each frame has two jammy. The JAMB hinge is aside where the curtains are installed, and the JAMB striking is aside where it fits into the strike. Jammy is also used to mount the frame to the surrounding wall. A horizontal member who connects two hard work is called a head. In most residential settings, the door frame is made of wood. It usually hides a housing or trim, so the type and surface of the wood is generally not important. For commercial use, the most common hollow metal door constipation are made of steel rolled for cold for internal applications or galvanized steel for external use. Some architects can specify stainless steel or aluminum frames to provide a nicer surface, while glass fibers are used for their durability and weather resistance.
there are severalIK components that go to the door composition. There is a face JAMB, a surface that is parallel to the wall. The JAMB stop is an impact that holds the door in place and prevents it from swinging straight across the frame. On both sides of the stop is known as Rabbet. Most JAMB door is equipped with one rabbet larger than the other, which means that the stop is not concentrated, although straight rabbet frames can be tailored.
When ordering the door frame, several details about JAMBs must be determined, starting with the size of the neck. HRK is the rear part of the laws of doors that are wrapped around the installation wall. It should be equal to the thickness of the wall where it is installed. It is also necessary to determine the types of hardware Be used. Each door load will then be prepared with cut -outs or reinforced with steel plates to adapt and support the hardware installation.
various fasteners are used to secure the door to the neighboring walls. For wooden frames, most types of nails and screws are acceptable. Metal framesThey require special anchors and usually these anchors must be ordered with a frame. In the case of brick walls, T-Kotva or wire anchor is welded to the Code and is then located between layers of brick or block. The anchor of the compression anchor is welded to the frame frame used in plasterboard and can be adjusted to match the walls after the position.